When you stand in the mall atrium and look up at the starry sky effect, are you also curious about where these stunning LED sky screens are hidden? More importantly - is it worthwhile to install this in your own store? Don't worry, let's dig out the secrets on the ceiling today.

Last year, when I was installing a sky screen for a chain coffee shop, my boss had to install an ultra-thin model at a height of 5 meters. As a result, during debugging, I found that the maintenance port could not reach the driver module at all. Later, the problem was solved by changing to modular design. ​ ​The installation position of this sky screen is really not up to you to install it wherever you want.​​。

​​Let’s talk about some counter-intuitive truths first​​：

1. The best viewing distance of the sky screen = screen height × 1.5 (for example, an 8-meter-high screen needs to be viewed 12 meters away to avoid dizziness)
2. Only models with a permeability of ≥80% can be used as glass curtain walls (otherwise it will look like a frosted film is attached during the day)
3. More than 30cm of space must be reserved for the heat dissipation channel (the most exaggerated case I have seen is that the ceiling was filled with screens and caused a fire alarm)

An Internet celebrity restaurant installed a sky screen in the open area, but on the day of its opening, there was smearing on the screen. After checking for a long time, I found that the air outlet of the air conditioner was blowing directly, causing the temperature control to be unbalanced. So​ ​The installation location should consider the ambient temperature and humidity, just like choosing a marriage partner depends on the family atmosphere.​​。

Now focus on——​ ​The golden point of the sky screen​​：

• Main atrium of commercial complex (preferably 8-12 meters above the ground)
• Transport hub transfer hall (to be calculated in conjunction with structural load-bearing)
• Brand flagship store entrance dome (note anti-glare design)
• Theater/cinema waiting area (blue light radiation must be controlled)

The most bizarre request I ever encountered was that a club wanted to use a sky screen as the roof of a swimming pool. It took three months to figure out the waterproof level alone, and finally a model with IP68 protection + special heat dissipation structure was customized. So​ ​Don’t buy universal models for special occasions. It’s like using a kitchen knife to chop bones – it’s not impossible, but it’s laborious.​​。

Newbies are most likely to stumble upon floor height estimates. A customer measured the floor height incorrectly. After installing the screen, there was only 20cm left from the chandelier. He was worried about short circuit every day. Here’s a native method:​ ​After measuring the layer height, first subtract 50cm and then calculate the screen thickness.​ ​, leaving room for wiring and heat dissipation.

You must ask: What configuration should I choose for different places? Based on the pitfalls I have encountered over the years, I compiled a comparison table:

Recently, there was a high-end real estate project, and the developer insisted on installing a liftable sky screen. It was found that the position of the embedded parts of the floor slab was 2 centimeters off, and the entire steel structure had to be reworked. so​ ​If you want to use black technology, you have to check the building conditions first. It’s like climbing a mountain in high heels - it’s not impossible, but you have to be prepared for foot pain.​​。

There is another unpopular knowledge point: the maintenance channel of the sky screen is 50% wider than that of the ordinary screen. Last year, in an airport project, due to lack of maintenance space, half of the screen had to be dismantled to replace a power board. The labor cost was ten times more expensive than the parts. so​ ​Before signing the contract, be sure to ask the builder to produce a three-dimensional simulation drawing.​ ​, don’t believe the words “you can definitely fix it”.

Editor’s point of view: Finding a spot to install a canopy screen is like finding a parking space—the good spots have already been taken up. If you really want to pretend, remember three points:​ ​First test the environmental data, then check the maintenance convenience, and finally compare the parameter configuration.​ ​. If you are really unsure, bring photos of the site and talk to the manufacturer. Regular companies now provide free survey services, which is better than guessing on your own.

for more product information and pricing, please contact us .