​​1. How to correctly start the LED synchronization screen? ​ ​

​​The core operation process is divided into three stages: hardware preparation, software configuration, and signal synchronization.​​：

1. ​​Hardware connection check​​

   
   • ​​Power system​ ​: Confirm that the switch on the back of the display is turned on and the mains power supply indicator light is green. Use the standard power cord to connect to the voltage regulator. Outdoor screens need to additionally check the lightning protection device.
   • ​​signal link​ ​: Priority is given to using HDMI 2.1 or DP 1.4 interface to connect to the control computer.​ ​High-standard wires can support 8K@120Hz lossless transmission​​

2. ​​Control system activation​​

   • Open the manufacturer's special control software and enter the initial password to enter the operation interface.
   • ​​Key parameters preset​ ​: Refresh rate ≥1920Hz, grayscale ≥16bit, color temperature 5000-6500K

​​2. How to accurately match synchronization signals? ​ ​

​​The display requirements of different scenarios correspond to differentiated synchronization solutions.​​：

​​Advanced operations include three core steps​​：

1. ​​Display area calibration​ ​: Draw synchronization area coordinates in the control software, and the error must be controlled within ±2 pixels.
2. ​​Signal source binding​ ​: Match graphics card output parameters through EDID codes to avoid resolution adaptation issues
3. ​​Redundant backup settings​ ​: Enable dual-signal hot standby function, active and standby link switching time ≤ 0.5 seconds

​​3. Routine maintenance and exception handling​​

​​Three rules to ensure stable operation​​：

1. ​​Power on and off sequence specifications​​

   • Correct process: Start the control computer → Turn on the power of the synchronization screen → Load the control software
   • Incorrect operation warning: direct power failure may cause damage to the driver chip

2. ​​Common troubleshooting table​​

   Phenomenon	Priority check items	solution
   Black screen no signal	Graphics card driver version	Upgrade to Studio driver
   Screen tearing	Sync frame rate settings	Enable vertical sync
   Color distortion	Gamut profile	Switch to BT.709 standard

3. ​​Long-term maintenance strategy​​

   • Perform weekly grayscale calibration to maintain color consistency
   • Update firmware quarterly to get the latest synchronization algorithm
   • Annual in-depth maintenance requires professional operations

Through standardized operating procedures and regular maintenance, the display performance of the LED synchronization screen can be maximized. In special scenarios, it is recommended to configure an intelligent temperature control system to ensure that core components operate in the optimal working range of 35-55°C.

for more product information and pricing, please contact us .